Hinge Preparations – Standard Please refer to the Hinge template for size and screw locations. Hinge backsets are fixed and cannot be changed. If ordering Timely frames prepared for other manufacturers’ vertical hinge locations, hinge backset on door must conform to hinge backset on frame.           Example: _35 235 2 ea. 3 1/2" hinges 335 3 ea. 3 1/2" hinges 435 4 ea. 3 1/2" hinges

Hinge Size

Timely’s Code

Radius

Depth

Screw Pattern

Electric Hinge Option

Templates

S

C

A

CK

AK

DE

P

1 3/8"

1 3/4"

3 1/2"

_35

1/4"

.100

Template

•

YES

YES

•

•

•

•

•

H-01

•

_35HW

1/4"

.123

Template

•

YES

YES

•

•

•

•

•

H-02

•

_35R

5/8"

.100

Template

•

YES

YES

•

•

•

•

•

H-03

•

4"

_40

1/4"

.120

Template

YES

YES

YES

YES

YES

YES

•

•

•

H-05

_40 MS-A

5/8"

.090

Non-Template

YES

YES

YES

YES

YES

YES

•

•

•

H-09

_40 MS-DD*

5/8"

.180

Non-Template

YES

YES

YES

YES

YES

YES

•

•

•

H-09DD

4 1/2"

_45

sq.

.134

Template

YES

YES

YES

YES

YES

YES

YES

•

•

H-15

_45HW

sq.

.180

Template

YES

•

YES

•

YES

•

YES

•

•

H-16

5"

_50

sq.

.145

Template

YES

YES

YES

YES

YES

•

YES

•

•

H-20

_50HW

sq.

.190

Template

YES

•

YES

YES

YES

•

YES

•

•

H_21

*double depth emboss

This preparation is a Reinforcement Only. Timely’s TA-58 Reinforcement Bracket is factory applied to the back side of the frame to provide a strong anchor for the continuous hinge of your choosing.

Timely’s Code

Electric Hinge Option

S

C

A

CK

AK

DE

P

Continuous

CONT

YES

YES

YES

YES

YES

YES

YES

•

View this video to learn about 3M’s VHB tape’s amazing strength

When using gear driven continuous hinges, a wide throw hinge must be used to avoid conflict between the gear housing and the casing. Standard throw gear driven hinges will contact the casing when the door is open approximately 80°.

Double Acting Hinges are attached to a cased opening jamb using standard machine screws.

In this installation, a TA-25 is jobsite applied to the center of the frame on the back side prior to installation on the wall. Once the frame is installed, the hinge screw holes are located and then drilled and tapped for machine screw threads. The door is mounted to the hinge flange and tested for proper operation. The door must be sized appropriately or the strike stile must have a radius to provide necessary clearance. Once the door is operating as required, the hinge springs are tightened using a tension bar to provide the necessary closing force.